Pioneer VSX-1018AH-S - Manual (Page 81)

Additional information 13
81
En
Video
Settings
Symptom Remedy
No image is output when an
input is selected. • Check the video connections of the source component (see page 17).
• For high-definition video (using component video connections), or when digital video conversion
is switched off (in
Setting the Video options on page 70), you must connect your TV to this receiver
using the same type of video cable as you used to connect your video component.
• Make sure the input assignment is correct for components connected using component or HDMI
cables (see
The Input Setup menu on page 65).
• Check the video output settings of the source component.
• Check that the video input you selected on your TV is correct.
Can’t record video. • Check that the source is not copy-protected.
• The video converter is not available when making recordings. Check that the same type of video
cable is used for connecting both the recorder and the video source (the one you want to record) to
this receiver.
Noisy, intermittent, or distorted
picture. • Sometimes a video deck may output a noisy video signal (during scanning, for example), or the
video quality may just be poor (with some video game units, for example). The picture quality may
also depend on the settings, etc. of your display device. Switch off the video converter and reconnect
the source and display device using the same type of connection (component, S-Video or
composite), then start playback again.
OSD does not appear. • The OSD will not appear if you have connected your TV using the COMPONENT VIDEO or S-VIDEO
MONITOR OUT. Use HDMI or composite connections.
Symptom Remedy
The Auto MCACC Setup
continually shows an error. • The ambient noise level may be too high. Keep the noise level in the room as low as possible (see
also
Problems when using the Auto MCACC Setup on page 10). If the noise level cannot be kept low
enough, you will have to set up the surround sound manually (page 41).
After using the Auto MCACC
Setup, the speaker size setting
is incorrect. • There may have been some low frequency noise in the room from an air-conditioner, motor, etc.
Switch off all other appliances in the room and use Auto MCACC Setup again.
• Depending on a number of factors (room size, speaker placement, etc.) this may occur in some
cases. Change the speaker setting manually in
Speaker Setting on page 48, and use the ALL (Keep
SP System) option for the Custom Menu in Automatic MCACC (Expert) on page 38 if this is a
recurring problem.
Can’t adjust the Fine Speaker
Distance setting (page 42)
properly. • Check that the speakers are all in phase (make sure the positive ( +) and negative (–) terminals are
matched up properly).
The display shows KEY LOCK
ON when you try to make
settings.
• With the receiver in standby, press  STANDBY/ON while holding down the SPEAKERS button to
disable the key lock.
Most recent settings have been
erased. • The power cord was disconnected from the wall while adjusting this setting.
VSX-1018AH_HY.book Page 81 Wednesday, February 27, 2008 9:08 PM