Resetting the system, Default system settings, Using other functions 11 – Pioneer VSX-1018AH-S User Manual
Page 73
Using other functions
11
73
En
Resetting the system
Use this procedure to reset all the receiver’s settings to
the factory default. Use the front panel controls to do this.
1
Switch the receiver into standby.
2
While holding down the front panel STEREO/A.L.C
button, press and hold
STANDBY/ON for about two
seconds.
The display shows
RESET?.
3
Press the front panel AUTO SURR/STREAM DIRECT
button.
The display shows
OK.
4
Press HOME THX to confirm.
OK appears in the display to indicate that the receiver
has been reset to the factory default settings.
• Note that all settings will be saved, even if the
receiver is unplugged.
Default system settings
Setting
Default
HDMI Audio
Amp
HDMI Control
ON
Digital Video Conversion
ON
Speakers
A
Surround Back System
Normal
Speaker System
Front
SMALL
Center
SMALL
Surr
SMALL
SB
SMALLx2
SW
YES
Crossover
80 Hz
X-Curve
OFF
THX Audio Setting
0.0–0.3m
Inputs
See
Input function default and possible settings on page 66.
MULTI-ZONE
Zone 2 Volume Type
Variable
Zone 2 Volume
–60 dB
SR+
SR+ Control On/Off
OFF
SR+ Volume Control On/Off
OFF
Monitor Out
OFF
DSP
Surround back channel Processing
ON
Phase Control
ON
Sound Retriever
OFF
Sound Delay
0.0 frame
Dual Mono
CH1
DRC
OFF
SACD Gain
0 dB
LFE Attenuate
0 dB
I/P Convert
AUTO
Auto delay
OFF
Digital Safety
OFF
Effect Level
Extended Stereo
90
Other modes
50
2 PL II Music
Options
Center Width
3
Dimension
0
Panorama
OFF
Neo:6 Options
Center Image
3 (Neo:6 Music)
10 (Neo:6
Cinema)
All Inputs
Listening Mode
(2 ch)
AUTO
SURROUND
Listening Mode
(x ch)
AUTO
SURROUND
Listening Mode
(HP)
STEREO
See also
Setting the Audio options on page 69 for other default
DSP settings.
MCACC
MCACC Position Memory
M1: MEMORY 1
Channel Level (M1–M6)
0.0 dB
Speaker Distance (M1–M6)
3.00 m
Standing Wave
(M1–M6)
ATT
0.0 dB
SWch Wide Trim
0.0 dB
EQ Data (M1–M6)
All channels/bands 0.0 dB
EQ Wide Trim
0.0 dB
Setting
Default
VSX-1018AH_HY.book Page 73 Wednesday, February 27, 2008 9:08 PM