Barco R5976562 - Manual (Page 96)

8. Installation Mode
8.3.3 CLO using Comm 800
What can be done?
CLO can be activated in a linked system setup using the COM800 Protocol + Ports.
By using the COM800 Protocol + Ports, the RS232 Ports can be used for a RS232 linked setup, CLO is received
through the COM800 Ports, general RS232 commands are received through the RS232 Ports.
How to change the COM800 Protocol Activation?
1. Push the cursor key ↑ or ↓ to highlight CLO using COM800: [NO]. (menu 8-9)
2. Press ENTER to toggle between [NO] or [YES].
[No] CLO will not use Comm800 protocol
[Yes] CLO will use Comm800 protocol
800 PERIPHERAL
OUTPUT MODULE [STANDARD]
CLO USING COMM800 [YES]
INFRARED [PPM]
Select with ↑ or ↓
then
to return
Menu 8-9
8.4 Source Switching
Switching from one source to another.
To minimize undesired effects when switching from one source to another one can use the Seamless switching mode, beside Seam-
less switching there is a choice between several effects which render the transitions more enjoyable.
How to select a switching mode
1. Push the cursor key ↑ or ↓ to highlight Source Switching. (menu 8-10)
2. Press ENTER to select.
The seamless source switching menu will be displayed. (menu 8-11)
3. Press ENTER to toggle between [NO TRANSITION], [FADE], ...
OFF no effect installed.
RANDOM TRANSITION source switching will happens with an effect, random chosen between the available effects.
See image 8-1.
INSTALLATION
INPUT SLOTS
800 PERIPHERAL
SOURCE SWITCHING
NO SIGNAL
CONTRAST ENHANCEMENT
CONVERGENCE
CONFIGURATION
LENS
QUICK ACCESS KEYS
OSD
INTERNAL PATTERNS
Select with ↑ or ↓
then
to return
Menu 8-10
SEAMLESS
SOURCE SWITCHING
EFFECT [NO TRANSITION]
to toggle
to return.
Menu 8-11
92 R5976562 BARCOSLM G10 PERFORMER 20/10/2004