Barco R5976562 - Manual (Page 116)

9. Service Mode
How to display the lamp menu
1. Push the cursor key ↑ or ↓ to highlight Lamp. (menu 9-26)
2. Press ENTER to select.
The lamp menu will be displayed. (menu 9-27)
SERVICE
IDENTIFICATION
CHANGE PASSWORD
CHANGE LANGUAGE
CHANGE PROJ. ADDRESS
SERIAL COMMUNICATION
NETWORK
LAMP
DIMMING
MORE...
Select with ↑ or ↓
then
to return
Menu 9-26
LAMP
Constant Light output [OFF]
Using [RS port]
Mode [NORMAL]
Serial number : R101111
Article number : R9840xxx
Run time : 10 hours
Remaining run time : 490
hours
Number of strikes : 10
Z_AXIS : 100
Select with ↑ or ↓
then
to return.
Menu 9-27
How to switch the constant light output?
1. Push the cursor key ↑ or ↓ to highlight Constant Light Output.menu 9-27
2. Press ENTER to toggle between [OFF], [SLAVE] and [MASTER].
[OFF] fixed power, no power adaptation.
[SLAVE] follows the master projector to adjust the CLO. When stand alone and the light output should be adjusted,
put on slave.
[MAS-
TER] master projector to control the CLO in a chain of projectors.
Linked port
1. Push the cursor key ↑ or ↓ to highlight Using.menu 9-27
2. Press ENTER to toggle between [RS port] or [Comm port].
[RS port] RS port is used to make a linked connection
[Comm port] Comm port is used to make a linked connection
Mode switching
1. Push the cursor key ↑ or ↓ to highlight Mode.menu 9-27
2. Press ENTER to toggle between [NORMAL] and [ECONOMIC].
normal normal light output
economic reduced light output (+ less noise)
9.10 Dimming
What is possible
The lamp can be dimmed in small steps only when the lamp is used in Normal mode. The dimming can be done between normal
mode and economic mode.
112 R5976562 BARCOSLM G10 PERFORMER 20/10/2004