Playback, Playing cds and wma/mp3 discs, Playing video cd/super vcds – Pioneer DVR-550H-S User Manual
Page 65
Playback
65
En
07
Playing CDs and WMA/MP3 discs
The table below shows the basic playback
controls for audio CDs
1
, and WMA/MP3
files.
Playing Video CD/Super VCDs
The table below shows the basic playback
controls for Video CD/Super VCDs.
Some discs feature Playback Control (PBC
for short) menus. These discs show PBC in
the display when you load them and display
a menu on-screen from where you can select
what to watch.
2
Press to skip to previous/next
chapter/title. (During playback
you can also use the front panel
CH +/–
buttons.)
During playback, enter a title
number then press
ENTER
to
skip directly to that title.
Press
CLEAR
to clear a number
entry and start again.
(Commercial back/skip) Each
press skips backward/forward
progressively up to a maximum
of two hours in either direction.
While paused, press and hold
to start slow-motion playback.
Press repeatedly to change the
playback speed.
While paused, press to advance
a single frame in either
direction.
Note
1 If you want to play a DTS audio CD, make sure the recorder is connected to a DTS-compatible amp/receiver with
a digital connection. Noise will be output through the analog outputs. Also make sure that
STEREO
is selected
using the
AUDIO
(
SHIFT
+
4
) button (see
Switching audio channels
on page 72).
Press to start playback.
Press to stop playback.
Pauses playback, or restarts
playback when paused.
PREV
NEXT
AUDIO
SUBTITLE
REC MODE
ANGLE
PLAY MODE
CLEAR
ENTER
CM
SKIP
CM
BACK
/
/
PLAY
STOP
PAUSE
Except WMA:
Press to start
scanning. Press again to
increase the scanning speed.
(There are two scan speeds; the
current scan speed is shown
on-screen.)
Press to skip to previous/next
track (or folder for WMA/MP3
disc). (During playback you can
also use the front panel
CH +/–
buttons.)
During playback, enter a track
number then press
ENTER
to
skip directly to that track.
Press
CLEAR
to clear a number
entry and start again.
Press to start playback.
Video CD only:
If
RESUME
is
displayed on-screen, playback
starts from the place last
stopped.
Press to stop playback.
Video CD only:
You can resume
playback from the same point
by pressing
PLAY
. (Press
STOP
again to cancel the
resume function.)
2 When playing in PBC mode, some playback features, such as search, repeat and programme play are not
available. You can play a PBC Video CD/Super VCD in non-PBC mode by starting playback using the Disc
Navigator (see
Using the Disc Navigator with playback-only discs
on page 68).
PREV
NEXT
AUDIO
SUBTITLE
REC MODE
ANGLE
PLAY MODE
CLEAR
ENTER
PLAY
STOP
07 Playback.fm 65 ページ 2007年1月6日 土曜日 午後7時45分