Pioneer DVR-550H-S - Manual (Page 135)

Additional information
135
En
16
Front-panel displays
The table below shows a list of error messages that you may encounter when using the
recorder and an explanation of their meaning.
• There is no DV input or the input
signal is unrecordable. No signal was detected at the DV IN jack. This may
appear if a blank section of DV tape is playing in
the connected camcorder.
• No DV camcorder connected. The camcorder is not connected properly, or the
camcorder is switched off.
• You cannot connect more than one
DV camcorder at a time. This recorder’s DV jack supports connection to
just one camcorder.
• Cannot operate the DV camcorder. This recorder cannot operate the DV camcorder.
Try switching off the camcorder then turn it back
on again.
• Could not operate the DV camcorder. This recorder was not able to operate the DV
camcorder.
• The DV camcorder is not set for
playback. Please select playback mode
on the DV camcorder. The camcorder is in camera mode. Switch it to
playback mode.
Message Explanation/Action
• E01 The HDD may be damaged or broken. Please ask
your nearest Pioneer-authorized service center or
your dealer to carry out repairs.
• E02 As the HDD info cannot be properly read, no new
recordings can be made. Reinitializing the HDD
(page 109) may result in your being able to make
recording again. Note that reinitializing the HDD
will erase all recorded contents, including
protected files.
HDCP ERR Displayed when a device that is not HDCP-
compatible is connected to the HDMI terminal.
Connect a device that is HDCP-compatible.
Message Explanation/Action
DVR550H_WV_EN.book 135 ページ ２００６年１２月２８日 木曜日 午後４時２１分