Resetting the audio functions 56, Other functions, Using the aux source 56 – Pioneer DVH-P5000UB User Manual
Page 56: Operating this unit, Resetting the audio functions, Using the aux source
2
Press MULTI-CONTROL to switch the di-
gital attenuator setting.
! HIGH – High quality sound
! LOW – Minimize distortion sound
Resetting the audio functions
Only when the multi-channel processor (e.g.,
DEQ-P6600) is connected to this unit, you can
operate this function.
You can reset audio functions other than the
following settings.
! Volume setting (refer to Adjusting the vo-
! Listening position setting (refer to Using
the position selector on page 68)
! Fader/balance setting (refer to Using bal-
! SLA (source level adjustment) setting (refer
to Adjusting source levels on page 70)
! Dynamic range control (refer to Using the
dynamic range control on page 70)
! Direct control setting (refer to Using the di-
! Down-mix setting (refer to Using the down-
1
Use MULTI-CONTROL to select
AUDIO RESET.
Refer to Adjusting initial settings on page 52.
2
Press MULTI-CONTROL to display OK.
# To cancel resetting the audio functions, press
BAND.
3
Push MULTI-CONTROL right to display
REALLY?.
# To cancel resetting the audio functions, press
BAND.
4
Press MULTI-CONTROL to reset audio
functions.
COMPLETE appears in the display.
Other Functions
Using the AUX source
Up to two auxiliary devices such as VCR or
portable devices (sold separately) can be con-
nected to this unit. When connected, auxiliary
devices are automatically read as AUX sources
and assigned to
AUX1 or AUX2. The relation-
ship between
AUX1 and AUX2 sources is ex-
plained below.
About AUX1 and AUX2
There are two methods to connect auxiliary de-
vices to this unit.
AUX1 source:
When connecting auxiliary device using a mini
plug cable
! If an iPod with video capabilities is con-
nected to this unit via 3.5 mm plug (4 pole)
cable (e.g., CD-V150M), you can enjoy the
video contents of the iPod.
! It is possible to connect a portable audio/
video player by using a 3.5 mm plug (4
pole) to RCA cable, which is sold sepa-
rately. However, depending on the cable, re-
verse connection between Red (right side
audio) cable and yellow (video) cable is re-
quired. Otherwise, audio and video may not
be correctly reproduced.
% Insert the mini plug into the AUX input
jack on this unit.
For more details, refer to the installation man-
ual.
This auxiliary device is automatically set to
AUX1.
AUX2 source:
When connecting auxiliary device using an IP-
BUS-RCA Interconnector (sold separately)
Operating this unit
En
56
Section
02