Pioneer X-SMC3-K - Manual (Page 28)

Changing the settings 12
28
En
Using the timer
Setting the clock
Setting the clock before using the timer. 1
1 Press SET UP.
The Initial Setup screen is displayed on the main display.
2 Select Clock Setting  Clock Adjustment.
3 Select Auto or Manual.
If you select Manual, go to step 4.
• Auto works only when this unit is connected to the
network. Connect to the network if you want to use
automatic time adjustment.
4 Use /// or number buttons to adjust
the clock, then press ENTER.
• Using / moves the adjusting digit (hour/minute/
second/AM, PM 2 ).
• Using / increases or decreases values.
• If you press RETURN, the previous screen will be
displayed.
Setting the wake-up timer
3
1 Press SET UP.
The Initial Setup screen is displayed on the main display.
Option Set
ting
BT PIN Select
(0000/1234/8888) Use this to set the Bluetooth PIN code. (page 18)
Volume Limit Setting
(On/Off) When On is selected, the volume can be set between 0 to 30.
Each time this setting has been changed, the volume becomes to 0.
Internet Parental Lock
(Change Password/Internet
Parental Lock) Restricts usage of internet radio using password. Select Internet Parental Lock to On/Off.
You can set up the password from Change Password. (page 32)
Auto mode select
(Power Save mode/Demo
Mode/Off) When Power Save mode is selected, the unit will be automatically in the standby mode if no
operation has done for more than 30 minutes.
When Demo Mode is selected, the demonstration screen will start if no operation has done for more
than 5 minutes.
Language
(English/Other languages) Change the language of the operation messages displayed on the main display.
Other languages: French, German, Netherlands, Italian, Spanish, Russian, Japanese
Quick Start Mode
(On/Off) When this is set to On, the time required for bootup will be shortened. In addition, power-on will
occur simultaneously when AirPlay is performed. Note, however, that when Quick Start Mode is set
to On, the electrical current consumed in the power-off (standby) mode will be about the same as
that required when the power is turned on. Also, if the power cord is disconnected while Quick Start
Mode is set to On, the next time the plug is reconnected, about one minute warm-up will be required
before the unit responds. Wait for one minute after reconnecting the cord before pressing
STANDBY/ON.
Software Update Use this to update unit software.
System Info Use this to check unit information details.
Settings What it does
Note
1 You’ll need to set the clock again if you unplug the unit (or in case of a power failure).
2 The “AM” and “PM” indicators appear only when the Time Format is set to the 12H mode.
3 When the unit is in iPod, FM, Internet Radio, or Aux modes, you can set the timer.
Clock Adjustment
2 21 0 AM
H:M:S AM/PM
X-SMC3_SYXZT8_En.book 28 ページ ２０１１年６月９日 木曜日 午後４時６分