Pioneer DVR-520H-S - Manual (Page 53)

Recording 06
53
En
English
• Press REC MODE to select FINE , SP , LP , EP or AUTO
(See Recording time and picture quality on page 46). If
Manual Recording is on, then you can also select the
MN setting.
• Use the / (cursor left/right) buttons to select the
Once , Daily or Weekly recording option.
• Press HDD to record to the hard disk drive, or DVD to
record to a DVD.
• Use the and buttons to switch VPS/PDC On
or Off .
2 After making the settings, press ENTER.
The program details are shown at the bottom of the
screen for a few seconds then the screen is automatically
exited.
• If you haven’t set up the guide channels (or at least
the guide channel for the ShowView programming
number that you entered), the recorder will prompt
you to enter the channel number that the TV program
is showing on.
Tip
• You can check the timer program settings by
pressing TIMER REC to display the timer recording
screen.
ShowView programming with the power off
You can enter a ShowView programming number when
the recorder is in standby. Note that the recording is
always made to the HDD. If you want to record to a DVD
disc, you’ll need to switch on the power and use the full
ShowView program screen.
Important
• You can’t use this feature until you have set up the
guide channels. See ShowView CH Setting on
page 101.
• You can’t change the recording mode.
• You can’t program daily or weekly timer recordings.
1 Press S HOW V IEW .
The front panel display shows the current recording
mode and prompts you to enter the ShowView
programming number.
2 Use the number buttons to enter the ShowView
programming number.
• To clear the last digit entered, press CLEAR .
• Use the PREV / NEXT button to switch VPS/
PDC on/off. With VPS/PDC on, the front panel VPS/
PDC indicator lights. (Note that a maximum of 8
timer recordings can be set with VPS/PDC on.)
3 Press ENTER.
The display shows the timer settings:
Date
Start time End time HDD and Recording
channel.
• If CODE ERROR appears in the display, check that
the ShowView programming number is correct and
that the guide channel is set (see
ShowView CH
Setting on page 101), then set the timer recording
again.
• If CAN’T SET appears in the display, it means that
although you entered a valid ShowView
programming number, the program has already
finished.
ENTER
CLEAR
PREV NEXT
ì
S HO W V IEW
2 9 32 4
DVR-04_HDD_EU.book 53 ページ ２００４年４月１１日 日曜日 午後１時４５分