Pioneer DVR-520H-S - Manual (Page 52)

Recording 06
52
En
VPS/PDC on.
Note that VPS/PDC may not work with every station
and that Optimized Recording will not work if VPS/
PDC is on.
• Ttl Name Input – Optionally, you can enter a name
for the recording up to 32 characters. (Highlight
Program Set then press (cursor down) to access
this option.)
4 After entering all the timer recording
information, highlight ‘Program set’ and press
ENTER.
The timer recording list screen is displayed again. The
timer program you just input appears in the list. The
rightmost column shows various timer recording status
messages:
• Standby is displayed when the recorder is in timer
recording standby.
• Recording is displayed when a timer recording is in
progress.
5 To exit the timer recording screen, press HOME
MENU.
Note
• For a DVD timer recording, if Optimized Rec (see
Optimized Rec on page 108) is set to On (and VPS/
PDC is off), the recorder will adjust the recording
quality to try and fit the recording on the disc. If the
recording will not fit onto the disc even on MN1
recording quality then the Recovery Recording
feature will automatically make the recording to the
HDD instead.
• If there is very little free space left on the HDD, an
Auto Replace Recording may not complete
successfully.
• If the HDD is being used for playback or high-speed
copying when an Auto Replace Recording is due to
start, the new timer recording will not replace the old
one. However, the next time the timer recording
starts, both of the older two programs will be erased.
• If you set the timer recording to use VPS/PDC, you
must switch the recorder into standby before the
timer recording is due to start for it to work correctly.
For non-VPS/PDC timer recordings there is no need
to switch the recorder into standby.
Tip
• Stations that use VPS/PDC typically include VPS/
PDC information in the teletext TV guide pages.
Please refer to these when setting your timer
recording.
Timer recording using the ShowView
™
programming system
This system makes programming timer recordings very
simple. Most TV guides publish ShowView programming
numbers with their program details. If you want to make
a timer recording of a program, you just input the
corresponding code. The date, start, stop and channel
settings are made automatically. All you have to do is tell
the recorder the recording mode, and whether it’s a
once-only recording or a regular recording.
1 Press S HOW V IEW to display the ShowView
program screen.
You can also access this screen from the Home Menu
(press
HOME MENU , select Timer Recording , then
ShowView ).
• Use the number buttons to enter the ShowView
programming number. (To clear the last digit
entered, press
CLEAR .)
HOME
MENU
HDD DVD
ENTER
CLEAR
REC MODE
ì
to input 3 9 9 2 4 0 9 ShowView#
Rec Mode
Rec Times
ShowView
MN21
Once Daily Weekly
REC MODE to change
to change level
to change
VPS/PDC Off to change
HDD DVD Rec to HDD to change
DVR-04_HDD_EU.book 52 ページ ２００４年４月１１日 日曜日 午後１時４５分