Pioneer VSX-909RDS - Manual (Page 65)

OPERA
TION
65
En
1 Set the remote control slide switch to
SETUP.
Also make sure that your TV is on and set to the receiver.
2 Press the REMOTE SETUP (INPUT ATT)
button.
The REMOTE SET UP menu appears on your TV screen.
Select Remote
Setup Mode
Remote SETUP+1
Preset Recall
Remote SETUP+2
Learning
Remote SETUP+3
Multi-Operation
Remote SETUP+4
Direct Function
You have four setup options:
1 Preset Recall
2 Learning
3 Multi Operation (See p.78)
4 Direct Function (See p.81)
Preset Recall and Learning are the two modes that teach the
remote control to operate your other components. It's easiest
to start with Preset Recall and, if setup isn't possible for certain
components, move on to the Learning mode.
3 Press the REMOTE SETUP button and 1 at
the same time to select the preset recall
setup mode.
All the MULTI CONTROL buttons (except the TUNER button)
start to blink.
To cancel the preset recall setup mode press REMOTE SET
UP.
Setting Up the Remote Control to Control Other
Components
In addition to controlling the receiver, the supplied remote control can operate your other components (VCR, TV,
LD, CD, etc.) after you program it to do so. In this way, instead of fumbling with many different controls and
buttons, you only need to use one remote control. If your component(s) are listed in the remote control's
memory, simply follow the steps below. If your component(s) are not listed, or if you want the remote to learn
additional operations, you can use the learning mode to input the information from the remote controls supplied
with your other components.
Recalling Preset Codes
The following steps show you how to recall preset codes stored in the remote control. Once a preset code is
recalled and the component assigned, you can use this remote to easily operate the component. See “Preset
Code List“ on page 88-91 for the components and manufacturers available.
AV PRE-PROGRAMMED AND LEARNING
REMOTE CONTROL UNIT
/DTS/MPEG
S0URCE
DVD/LD TV/SAT VCR1 VCR2
CD
TV VOL
TV FUNC
MENU
ENTER
STEREO/
DIRECT DSP
THX LIGHT
MUTE
TV
VOLUME
MD/
TAPE1 TUNER TVCONT
RECEIVER
USE SETUP
MULTI
OPERATION
CLASS MPX DIRECT ACCESS
CHANNEL
STATION TUNING
DISPLAY RF ATT
TV CONTROL
FUNCTION
REMOTE SETUP
SYSTEM SETUP
INPUT
ATT
ADVANCED
MIDNIGHT MULTI CH
INPUT
STANDARD
DIGITAL NR
EFFECT/
CH SEL
SIGNAL
SELECT
BAND
SYSTEM
OFF
1 2 3
4 5 6
7 8 9
0
DISC
Î
¶ 8 7 3
1 ¡ 4 ¢
+ -
+ -
+ -
MULTI CONTROL
+ +
– –
+
–
+10
1
3
2,3
Remote Control of Other Components
Before operating the receiver, be sure to press the
_ ON/ — OFF button on the front panel to turn the
power ON ( _).