Pioneer VSX-909RDS - Manual (Page 22)

22
En
Display
All the display information is explained and/or referenced here.
4 Speaker indicators
Light to indicate the current speaker system, A
and/or B.
5 LOUDNESS indicator (See p.50)
Lights when the LOUDNESS mode is on.
6 H.P (headphones)
Lights when headphones are connected to the
PHONES jack (speakers systems A and B both
turn off automatically).
7 MIDNIGHT indicator (See p.50)
Lights when the MIDNIGHT LISTENING mode
is on.
8 DSP indicator (See p.42-46,48)
Light when a DSP or Advanced Theater modes
are selected.
9 STEREO indicator
Lights when a STEREO mode is selected.
10 Function indicator
Displays the function.
11 2 /dts/MPEG mode indicators
2 DIGITAL : When the 2 /dts/MPEG mode on
the receiver is on, this indicator lights to indicate
playback of a Dolby Digital signal. However,
2
PRO LOGIC lights during 2 channel playback of
Dolby Digital.
2 PRO LOGIC : When the 2 /dts/MPEG mode
on the receiver is on, this indicator lights during 2
channel playback.
dts : Lights when DTS signals are input.
THX: Lights when the HOME THX CINEMA mode
is selected.
MPEG: Lights when MPEG signals are input.
12 MASTER VOLUME indication
Displays current volume level.
1 SIGNAL SELECT indicators
Light to indicate the input signal you selected.
ANALOG : Lights when analog signals are
assigned.
DIGITAL : Lights when digital audio signals are
selected.
AC-3 RF : Lights when AC-3 RF signals are
assigned.
AUTO : Lights when the receiver is set to select
the input signal automatically.
2 Program Format indicators
AC-3 : Lights when a source with Dolby Digital
signals is played.
DTS: Lights when a source with DTS audio signals
is played.
MPEG: Lights when a source with MPEG audio
signals is played.
For Dolby Digital or DTS sources, these
indicators change according to which channels
are active in the source. When all three LS (left
surround), S (surround) and RS (right surround)
light at the same time it means a Source with
Surround EX or DTS-ES flag is being used.
L – Left front channel.
C – Center channel.
R – Right front channel.
LS – Left surround channel.
S – Surround channel (mono).
RS – Right surround channel.
LFE – Low Frequency Effects channel.
3 Analog level indicators
OVER – When the source signal is analog, this
lights if the signal is in danger of distorting.
Press INPUT ATT on the remote control to
lower the signal level.
ATT – Lights when INPUT ATT is used to
reduce the level of the analog source signal.
DIGITAL
dB
PRO LOGIC
STEREO DSP MIDNIGHT LOUDNESS ATT SIGNAL
SELECT OVER H.P
ANALOG SP AB
L C R LFE
LS S RS
DIGITAL
AC-3RF
AUTO TAPE 2
VOLUME
AC-3DTS MPEG
EON
RDS RF ATT
MPEG
MONO STEREO
TUNED AMFM
1 3 4 5 6 7 8 9 10 11 12 13
14 15
2
Displays & Controls