Set up multi channel in setting, 1 use the 5¥∞ buttons to select multi channel in, 3 use the 5¥∞ buttons to select exit – Pioneer VSX-909RDS User Manual

Page 41: Multi channel in setting using the main unit, Initial set up, Multi ch input standby/on, The default setting is bypass

SET

Multi Channel In Setting

If you have a Multi Channel external decoder you can choose whether to have the sound level set to BYPASS, in
which case only the main volume can be controlled, or to ADJUST, which means the levels can be reduced in
volume. If continuing from Dynamic Range Control go to step 1. If starting fresh, complete steps 1-3 in “Setting
Up for Surround Sound“ (p.30) first.

1 Use the

5¥∞ buttons to select MULTI

CHANNEL IN.

See “Setting Up for Surround Sound“ on page 30 if you need
more information.

Press the ENTER button.

This information will be displayed on your TV.

Multi channel in

Select mode
[

Channel Level

]

[EXIT]

[BYPASS]

2 Use the

2¥3 buttons to select the setting

you want, BYPASS or ADJUST.

ADJUST: Use the ADJUST setting when you want to be able
to control each channel level individually.

BYPASS: This setting is good for getting the cleanest possible
signal. In this setting you won’t be able to change each channel
individually.

We recommend using BYPASS and the default setting is
BYPASS.

3 Use the

5¥∞ buttons to select EXIT.

Press the ENTER button.

You wil return to the SYTEM SETUP mode.

Multi Channel In Setting Using the Main Unit

You can also use the main unit to change the sound level of the MULTI CH IN. Folow the step below.

1 Put receiver in the STANDBY mode.

2 While holding down the MULTI CH

INPUT button press the

STANDBY/ON button.

The setting will change depending on what state
the receiver was previously in. For a few seconds
the display will show you which MULTI CH setting
you are now in.

MULTI CH INPUT

STANDBY/ON

AV PRE-PROGRAMMED AND LEARNING

REMOTE CONTROL UNIT

1-3

/DTS/MPEG

S0URCE

DVD/LD

TV/SAT

VCR1

VCR2

TV VOL

TV FUNC

MENU

ENTER

STEREO/

DIRECT

DSP

THX

LIGHT

MUTE

VOLUME

MD/

TAPE1

TUNER

TVCONT

RECEIVER

USE

SETUP

MULTI

OPERATION

CLASS

MPX

DIRECT ACCESS

CHANNEL

STATION

TUNING

DISPLAY

RF ATT

TV CONTROL

FUNCTION

REMOTE SETUP

SYSTEM SETUP

INPUT

ATT

ADVANCED

MIDNIGHT

MULTI CH

INPUT

STANDARD

DIGITAL

EFFECT/

CH SEL

SIGNAL

SELECT

BAND

SYSTEM

OFF

DISC

MULTI CONTROL

–

+10

Initial Set Up

memo

The default setting is BYPASS.

This manual is related to the following products:

VSX-909RDS-G