This message is displayed when the RETRIEVE key is touched
and the design in the machine’s memory is from a different
memory card than is currently inserted.
Memory card patterns cannot be saved into the machine’s
memory. However, the characters from memory card #1, the
Alphabet card and #10, Monogram emblem card, can be saved
and retrieved while the card is inserted. The card that the
design was saved from must be inserted in order to retrieve the
design.

This message is displayed when you are trying to save patterns
that cannot be combined.

This message is displayed if “CARD” is touched while no
memory card is inserted.

This message is displayed when the “START/STOP” button is
pressed but the presser foot has not been raised to change the
thread color.
If you are not changing the thread color, raise the presser foot
lever, lower it again, and then press the “START/STOP” button
to start the machine.

This message is displayed if an attempt is made to move the
embroidery frame while the needle is in the down position. Use
the balance wheel to move the needle to the highest position.
Then continue.

This message is displayed if the combined size of patterns
exceeds the size of the embroidering area.

This message is displayed if the needle is in the down position
when the power is turned on.

This message is displayed if “MULTI COLOR” is pressed when
pattern embroidering has already began.