Setting the bobbin – Brother PERSONAL EMBROIDERY SYSTEM PE-150 User Manual
Page 18
15
Setting the bobbin
1
2
The bobbin cover is located in front of the needle plate.
1. Slide open the bobbin cover by pushing the bobbin release
button to the right.
1
Bobbin cover
2
Bobbin cover release button.
2. Insert the bobbin into the shuttle following the thread
direction as noted in the etching under the bobbin cover.
*
(Use a plastic bobbin as shown on page 6)
3. Guide the thread end around the finger through the channel
toward the back, pulling the thread toward you which will cut
off any excess.
2
1
4. Close the bobbin cover by placing the left end in place and
pressing down lightly on the right end to snap in place.
*
There is no need to pull up the lower (bobbin) thread, it is
done automatically.
Embroidery can begin without pulling out the lower thread.