Pioneer AVIC-F910BT - Manual (Page 36)

= For more details of the operation, refer to
Replacing the location as the new final desti-
nation on this page.
Starting Point
Sets the location as a starting point.
= For more details of the operation, refer to
Setting the location as the start point on the
next page.
Save as...
Add Pin
Puts a map pin at the cursor position as a
mark up.
= For details, refer to Placing a map pin on the
location on the next page.
Add POI
Stores the cursor position as a POI.
= For details, refer to Registering the location
as a customised POI on page 38.
Add Favourite
Stores the cursor position as one of the
“Fa-
vourites
”.
= For details, refer to Storing the location in
“Favourites” on page 39.
Add Cam
Stores the cursor position as a safety camera
location.
= For details, refer to Storing the position as a
safety camera location on page 39.
Setting the location as a
new destination
1 Touch [Route...] on the
“Map Confirmation Screen”.
2 Touch [Go Here Now].
When the route is not set, route calculation
starts immediately.
When a route has already been set, a message
will appear asking you to cancel it. Touch [
Yes]
to start the route calculation.
p When the cursor overlaps with a destina-
tion that has already been set, touch [ Re-
move Dest.] to cancel the current route or
recalculate the route by setting one of the
remaining waypoints as the destination.
Setting the location as a
waypoint
1 Touch [Route...] on the
“Map Confirmation Screen”.
2 Touch [Add Via].
p When the cursor overlaps a waypoint al-
ready set, touch [ Remove Via] to delete the
waypoint and recalculate the route.
Replacing the location as
the new final destination
1 Touch [Route...] on the
“Map Confirmation Screen”.
2 Touch [Continue].
p Recalculates the route by setting the cursor
position as the new destination. The pre-
vious destination becomes a waypoint.
After the location is decided (Map Confirmation Screen)
Engb
36
Chapter
04