Pioneer X-HM50-K - Manual (Page 7)

11/2/23 X-HM50_En.fm
7
System connections
Connect the supplied DAB/FM aerial wire to the DAB/
FM socket and position the DAB/FM aerial wire in the
direction where the strongest signal can be received.
Note
Placing the aerial on the unit or near the AC power lead
may cause noise pickup. Place the aerial away from the
unit for better reception.
Photo and video files from iPod or iPhone can be viewed
by connecting the system to TV/monitor.
If the TV/monitor has a video input, connect it to the
VIDEO OUT socket at the back of the unit and set the TV
Out on the iPod or iPhone unit to “ON” position.
Note
Please make sure to set iPod unit to either NTSC or PAL
to match your TV signal. Please visit Apple’s homepage
for further information.
After checking all the connections have been made
correctly, plug the AC power lead of this unit into the
wall socket.
Note
Unplug the AC power lead from the wall socket if the
unit will not be in use for a prolonged period of time.
CAUTION
Handle the power cord by the plug part. Do not pull out
the plug by tugging the cord, and never touch the power
cord when your hands are wet, as this could cause a
short circuit or electric shock. Do not place the unit, a
piece of furniture, or other object on the power cord or
pinch the cord in any other way. Never make a knot in the
cord or tie it with other cables. The power cords should
be routed so that they are not likely to be stepped on. A
damaged power cord can cause a fire or give you an
electric shock. Check the power cord once in a while. If
you find it damaged, ask your nearest Pioneer authorized
independent service company for a replacement.
Before making or changing the connections, switch off the power and disconnect the power cord from the AC outlet.
Right speaker
DAB/FM aerial
To video input socket
Wall socket
(AC 220 V to 230 V, 50 Hz/60 Hz) Video cable
(not supplied)
TV
Left speaker
n DAB/FM aerial connection
n Speaker connection
• Twist exposed wire strands together.
• Connect the red wire to the plus (+)
terminal, and other wire to the
minus (–) terminal.
• Use speakers with an impedance of
4 ohms - 16 ohms, as lower impedance
speakers can damage the unit.
• These speaker terminals carry HAZARDOUS LIVE
voltage . To prevent the risk of electric shock when
connecting or disconnecting the speaker cables,
disconnect the power cord before touching any
uninsulated parts.
• Do not attach these speakers to the wall or ceiling,
as they may cause injury in the event of a fall.
• Do not mistake the right and the left channels. The
right speaker is the one on the right side when you
face the unit.
• Do not let the bare speaker wires touch each other.
• Do not allow any objects to fall into or to be placed in
the bass reflex ducts.
• Do not stand or sit on the speakers. You may be injured.
• Do not connect the supplied speakers with any other
amplifier. This may result in malfunction or fire.
Incorrect
n Connecting iPod or iPhone to TV
n AC power connection