Subwoofer controller 52, Initial settings, Selecting the illumination color – Pioneer DEH-P8400MP User Manual
Page 52: Setting the rear output and sub- woofer controller

09
Section
Selecting the illumination color
This product is equipped with two illumination
colors, green and red.
You can select the desired illumination color.
1 Press
OPEN
to open the front panel.
2 Press
FUNCTION
to select
ILL
.
Press
FUNCTION
until
ILL
appears in the dis-
play.
3 Select the desired illumination color with
2/3.
Pressing
2/3 will switch
ILLUMI
between red
or green and that status will be displayed (e.g.,
ILLUMI :GRN
).
Setting the rear output and sub-
woofer controller
This product’s rear output (rear speaker leads
output and RCA rear output) can be used for
full-range speaker (
Rear SP:FULL
) or subwoofer
(
Rear SP:S.W
) connection. If you switch rear
output setting to the
Rear SP:S.W
, you can con-
nect a rear speaker lead directly to a subwoofer
without using an auxiliary amp.
Initially, the unit is set for rear full-range speaker
connection (
Rear SP:FULL
).
When rear output are connected to full range
speakers (when
Rear SP:FULL
is selected), you
can connect the RCA subwoofer output to a
subwoofer. In this case, you can select whether
to use the subwoofer controller’s (low pass
filter, phase) built-in
S.W Control:INT
or the
auxiliary
S.W Control:EXT
.
Notes
• Even if you change this setting, there is no
output unless you switch the non fading out-
put (refer to page 47) or subwoofer output
(refer to page 46) in the Audio Menu on.
• If you change the subwoofer controller, sub-
woofer output and non fading output in the
Audio Menu return to the factory settings.
• Both rear speaker leads output and RCA rear
output are switched simultaneously in this
setting mode.
1 Press
OPEN
to open the front panel.
2 Press
FUNCTION
to select
SW
.
Press
FUNCTION
until
SW
appears in the dis-
play.
3 Change the rear output setting with
5/∞.
Pressing
5/∞ will switch between
Rear SP
:FULL
(full-range speaker) and
Rear SP:S.W
(subwoofer) and that status will be displayed.
Notes
• When no subwoofer is connected to the rear
output, select
Rear SP:FULL
.
• When a subwoofer is connected to the rear
output, set for subwoofer
Rear SP:S.W
.
• When the rear output setting is
Rear SP:S.W
,
you cannot change the subwoofer controller.
4 Change the subwoofer controller with
2/3.
Pressing
2/3 will switch between
S.W Control:INT
and
S.W Control:EXT
and that
status will be displayed.
Initial Settings
En
52