Pioneer DEH-P8400MP - Manual (Page 46)

Audio Adjustments
Each press of
5 or ∞ increases or decreases
the treble level. +6 – –6 is displayed as the level
is increased or decreased.
Adjusting loudness
Loudness compensates for deficiencies in the
low- and high-sound ranges at low volume.
1 Press OPEN to open the front panel.
2 Press AUDIO to select Loud .
Press AUDIO until Loud appears in the display.
3 Press
5 to turn loudness on.
Loudness level (e.g., Loud Mid ) appears in the
display.
4 Press
2 or 3 to select the level.
Press
2 or 3 until the desired level appears in
the display.
Low (low)— Mid (mid)— High (high)
5 Press ∞ to turn loudness off.
Loud OFF appears in the display.
Using subwoofer output
This unit is equipped with a subwoofer output
which can be switched on or off.
1 Press OPEN to open the front panel.
2 Press AUDIO to select Sub-W1 .
When the Subwoofer Controller setting is S.W
Control:EXT , you can select Sub-W1 . Press
AUDIO until Sub-W1 appears in the display.
3 Press
5 to turn subwoofer output on.
Sub-W1 Normal appears in the display.
Subwoofer output is now on.
• You can turn off subwoofer output by pressing
∞.
4 Press
2 or 3 to select the phase of sub-
woofer output.
Press
2 to select reverse phase and
Rev.
appears in the display. Press
3 to select normal
phase and Normal appears in the display.
Adjusting subwoofer settings
When the subwoofer output is on, you can
adjust the cut-off frequency and the output level
of the subwoofer.
1 Press OPEN to open the front panel.
2 Press AUDIO to select Sub-W2 .
When the subwoofer output is on, you can
select
Sub-W2 . Press AUDIO until Sub-W2 80
(Hz) appears in the display.
• If the subwoofer setting has been previously
adjusted, the frequency of that previously
selected will be displayed, such as
50 (Hz) or 125
(Hz).
3 Press
2 or 3 to select cut-off frequency.
Press
2 or 3 until the desired cut-off frequency
appears in the display.
50 — 80 — 125 (Hz)
• Only frequencies lower than those in the
selected range are output from the subwoofer.
4 Press
5 or ∞ to adjust the output level of
the subwoofer.
Each press of
5 or ∞ increases or decreases
the level of the subwoofer. +6 – –6 is displayed
as the level is increased or decreased.
Press
5 or ∞ until you see the desired value
displayed.
En 46
08
Section