Setting the rear output and subwoofer controller, Switching the muting/attenuation – Pioneer AVIC-60D-2 User Manual
Page 154
152
■Setting the rear output and subwoofer controller
Pioneer AV Head Unit’s (AVH-P6400CD or AVH-P6400R) rear output (rear speaker leads
output and RCA rear output) can be used for full-range speaker (“REAR SPEAKER:FULL”)
or subwoofer (“REAR SPEAKER:SUBWOOFER”) connection. If you switch rear output
setting to the “REAR SPEAKER:SUBWOOFER”, you can connect a rear speaker lead
directly to a subwoofer without using an auxiliary amp.
Initially, the Pioneer AV Head Unit (AVH-P6400CD or AVH-P6400R) is set for rear fullrange
speaker connection (“REAR SPEAKER:FULL”).
When rear output are connected to full range speakers (when “REAR SPEAKER:FULL” is
selected), you can connect the RCA subwoofer output to a subwoofer. In this case, you can
select whether to use the subwoofer controller’s (low pass filter, phase) built-in “S.W. CON-
TROL:INTERNAL” or the auxiliary “S.W. CONTROL:EXTERNAL”.
➲
Even if you change this setting, there is no output unless you switch the non fading output
(refer to page 148) or subwoofer output (refer to page 148) in the audio menu on.
➲
If you change the subwoofer controller, subwoofer output and non fading output in the
audio menu return to the factory settings.
➲
Both rear speaker leads output and RCA rear output are switched simultaneously in this
setting mode.
1
Press
5 or ∞ to select “REAR SPEAKER” from the INITIAL SETTINGS MENU, and
press A.MENU (AUDIO) button.
2
Change the rear output setting with
5/∞.
Pressing
5/∞ will switch between “REAR SPEAKER:FULL” (full-range speaker) and
“REAR SPEAKER:SUBWOOFER” (subwoofer).
➲
When no subwoofer is connected to the rear output, select “REAR SPEAKER:FULL”.
➲
When a subwoofer is connected to the rear output, set for subwoofer “REAR
SPEAKER:SUBWOOFER”.
➲
When the rear output setting is “REAR SPEAKER:SUBWOOFER”, you cannot change
the subwoofer controller.
3
Change the subwoofer controller with
2
2
2
2 / 3
3
3
3.
Pressing
2
2
2
2 / 3
3
3
3 will switch between “S.W. CONTROL:INTERNAL” and “S.W. CON-
TROL:EXTERNAL”.
■Switching the Muting/Attenuation
This setting controls whether the volume of the AV Head Unit is automatically muted during
voice guidance. When a call is made or received using a cellular telephone connected to Pio-
neer AV Head Unit (AVH-P6400CD or AVH-P6400R), you can select between muting and
attenuation when using the Handsfree Telephone Unit.
1
Press
5 or ∞ to select “TEL/GUIDE MUTE/ATT” from the INITIAL SETTINGS MENU,
and press A.MENU (AUDIO) button.
2
Switch the telephone muting/attenuation with
2
2
2
2 / 3
3
3
3.
Pressing
2
2
2
2 / 3
3
3
3 will switch between “TEL/GUIDE:MUTE” (muting),
“TEL/GUIDE:ATT” (attenuation) and “TEL/GUIDE:NORMAL” (normal).
MUTE :
Volume is turned to 0.
ATT :
Volume is set to 1/4.
NORMAL : Volume remains the same.