Pioneer X-HM71-S - Manual (Page 26)

8 8
26
Internet radio
Connecting using PIN Input
1
Press NETWORK  SETUP. Select Network Setting 
WPS  PIN Input, then press ENTER.
2
Use / to select the access point which you want to
connect, then press ENTER.
3
Confirm the PIN code of this receiver, then press ENTER.
The PIN code of this receiver is shown on the display.
You must check this PIN code to connect to the network.
4
Within 2 minutes after closing the PIN Code message,
input the PIN Code to the access point selected in step 2.
The connection success or failure is displayed on the
display. The PIN Code input method differs depending on
the LAN device used. For details, consult the operating
instructions accompanying your LAN device.
Connecting to a router without WPS-PBC
function
This section describes how to set the network connection
using Safari browser on a Macintosh computer.
Be sure your computer is equipped with wireless LAN
function. Settings can be performed from the Web browser of
the computer.
1
Be sure the LAN cable is not connected to the receiver.
2
Plug the power cord into an AC outlet. Press STANDBY/
ON.
3
Press NETWORK  SETUP on the remote control.
4
Select Network Setting  Network Configuration 
Wireless  Web Control.
5
Select Start  OK.
The receiver restarts. Change settings on Web Control on
your computer.
6
Select Pioneer Setup (this receiver) in the available
wireless network connection of your computer.
SSID is displayed as Pioneer Setup:xxxxxx. "xxxxxx" is the
lower three bytes of the MAC address.
You can change this receiver's network settings via Safari
browser.
Note
• This setting for the network has been confirmed for Mac OS
X 10.7 and Safari 5.1.
7
Launch Safari on your computer.
8
Press Bookmark icon. Click Bonjour list (a), and then
select this receiver's name (Friendly Name) (b) in
Bookmark.
If Bonjour list is not displayed, access the IP address
http://192.168.1.1/ from Safari.
If you use X-HM71 or X-HM81, XC-HM71 or XC-HM81 is
displayed as the receiver's name.
9
Click Network Configuration. Select Auto and then press
OK.
10
Setup the network settings manually and then press
Apply.
If SSID is not displayed, return to step 9 and select
Manual
.
The receiver restarts and the new network settings are applied
to the receiver.
002XXXXXX
001XXXXXX
Available Wireless Networks
003XXXXXX
[ENTER]
88192420
Start
000001
000002
000003
XX.XX
:xxxxxx
a
b