Billion Electric Company 400G - Manual (Page 8)

Billion 400G Router
Chapter 2: Installing the router
5
The Ethernet Port # 4 can be used as a console port. You need a special console
tool which already includes in the package to connect with LAN port 4 and PC’s
RS-232 port (9-pin serial port).
The Rear Ports
Port Meaning
1
Antenna Connect the detachable antenna to this port.
2
ADSL
Use the supplied RJ-11 (“telephone”) cable to connect this port to
the ADSL/telephone wall jack.
3
LAN
1X — 4X
(RJ-45 connector)
To connect your router to a PC or an office/home network of
10Mbps or 100Mbps use a UTP Ethernet cable (Cat-5 or Cat-5e)
and connect to one of the LAN ports.
Caution: Port 4 can be either a LAN or a Console port at any time but
not simultaneously.
4 WPS Press the WPS button to trigger Wi-Fi Protected Setup function.
5 RESET
When the router is turned on the reset button is used to:
Reset the router: press for 1-3 seconds.
Restore factory default settings: press for 6 – 8 seconds, and
power cycle the router: (useful if you cannot login to the router
or have forgotten your Username/Password.)
Caution: After pressing the RESET button for 6 - 8 seconds, be sure
you power cycle the device.
If the RESET button is pressed for more than 10 seconds, the device
will need to be power cycled before normal operation can be resumed.
6
Power
Connect the supplied power adapter to this jack.
7
Power Switch
Power ON/OFF switch
3 1 2
4
6 7
5