Olympus PT-020 - Manual (Page 8)

Buckle cam
groove
Boss
E-14 E-13
Setting the Zoom Lever
When loading the digital camera
in the Case, fit the projecting
part of the zoom lever of the
digital camera into the recessed
part of the zoom lever on the
inside of the Case.
Power Switch Lever Operation Method
Use the power switch lever
to turn the camera on and
off.
: • When loading the camera, confirm that the projecting
part of the zoom lever of the camera is properly set to
the recessed part of the zoom lever of the Case.
• When the setting is insufficient, the loading of the
camera becomes imperfect and it may not be
possible to seal the Case or zooming may not
function. Insufficient sealing will cause water leakage.
CAUTION
: • When the digital camera is not used for about 3
minutes while in the shooting mode, it enters the
sleep mode (standby status) and no operations are
possible.
To cancel sleep mode (and return to operation
status), press the shutter button or any other button.
For details, refer to your digital camera's instruction
manual.
CAUTION
: • If the standard port is attached improperly to the case,
water penetration may result. Also make sure that the
buckles on the left and right of the standard port are
clamped firmly.
CAUTION
Removing
1
First make sure that the case is dry, and then
turn each buckle slowly in the opening direction
(counterclockwise).
2
When the two buckles have been turned by
about 110 degrees, the standard port begins to
separate from the case.
3
Continue turning the buckles slowly until the
standard port separates completely from the
case.
Attaching
1
Align the cam grooves of the buckles on the left
and right of the standard port with the bosses
on the case.
2
Fit the bosses into the left and right buckles
and fit the standard port into the case while
slowly turning the buckles clockwise.
3
Turn the two buckles clockwise until they stop
to secure the standard port.
❈ Refer to the Wide Port for PT-020's (optional PPO-02) instruction
manual for detailed instructions on using it.
Removing/attaching the standard port
The standard port attached to the case should be removed when
the Wide Port for PT-020 (optional PPO-02) is used.
The standard port can be removed and attached as follows.
Power switch
lever
PT_020JE_E-四.qxd 2003.11.27 17:07 ページ E-13 (1,1)