Olympus PT-030 - Manual (Page 37)

E-36
Maintenance of the TTL Connector Cap
After removing the TTL connector cap from the waterproof cap, be sure
to clean and grease the O-ring.
Use the waterproof cap maintenance adapter to remove the O-ring unit
from the waterproof cap.
Insert the adapter by aligning its pin with
the hole on the cap.
Turn the adapter counterclockwise to
remove the O-ring unit.
After removing the O-ring attached to the
O-ring unit, clean the O-ring groove and
apply silicon grease to the O-ring. Then,
re-attach the O-ring to the O-ring unit.
❈ Reverse the removal procedure to re-attach the O-ring unit to the
waterproof cap.
1
2
3
O-ring
Waterproof cap Waterproof cap
maintenance adapter
PT_030_EN.qxd 05.10.28 6:34 PM ページE-36