Olympus E-P5 - Manual (Page 53)

53 EN
Live control
3
Reducing camera shake (image stabilizer)
You can reduce the amount of camera shake that can occur when shooting in low light
situations or shooting with high magnifi cation. The image stabilizer starts when you
press the shutter button halfway.
1 Display the live control and select the image
stabilizer item using
FG.
WB
AUTO
WB WB WB
AUTO AUTO AUTO
L F
4:3
j
WB
AUTO
WB WB WB
AUTO AUTO AUTO
mm mm
50 50
HD
S-IS S-IS
S-IS S-IS S-IS S-IS S-IS S-IS OFF OFF S-IS AUTO S-IS AUTO P
Focal Length
Auto
2 Select an option with HI and press Q.
Still
picture
OFF S-I.S. Off Image stabilizer is off.
S-IS1 Auto Image stabilizer is on.
S-IS2 Vertical IS
Image stabilization applies only to vertical
(
Y) camera shake. Use when panning the
camera horizontally.
S-IS3 Horizontal IS
Image stabilization applies only to horizontal
(
Z) camera shake. Use when panning the
camera horizontally with the camera held in
portrait orientation.
S-IS AUTO
Landscape
Panning I.S. The camera detects the panning direction and
applies the appropriate image stabilization.
Movie
OFF M-I.S. Off Image stabilizer is off.
ON Movie-I.S.
In addition to Auto image stabilization, camera
shake that occurs when shooting while
walking is also reduced.
Choosing a focal length (Micro Four Thirds/Four Thirds System lenses excluded)
Use focal length information to reduce camera shake when shooting with lenses that are not
Micro Four Thirds or Four Thirds system lenses.
• Select [Image Stabilizer], press the INFO button, use HI to select a focal length, and
press Q.
• Choose a focal length between 8 mm and 1000 mm.
• Choose the value that most closely matches to the one that is printed on the lens.
# Cautions
• The image stabilizer cannot correct excessive camera shake or camera shake that occurs
when the shutter speed is set to the slowest speed. In these cases, it is recommended
that you use a tripod.
• When using a tripod, set [Image Stabilizer] to [OFF].
• When using a lens with an image stabilization function switch, priority is given to the lens
side setting.
• When priority is being given to the lens side image stabilization and the camera side is set
to [S-IS-AUTO], [S-IS1] is used instead of [S-IS-AUTO].
• You may notice an operating sound or vibration when the image stabilizer is activated.