Olympus DS-3400 - Manual (Page 18)

18
1
• You can choose the order of the year, month,
day by pressing the F2(D/M/Y or Y/M/D or M/
D/Y)* button while setting them.
Example: March 15, 2009
(Initial setting)
*The display will vary depending on the status of the
settings.
3 Press the PLAY/OK button to complete
the setup screen.
The clock will start from the set date and time.
Press the PLAY/OK button according to the time
signal.
Changing the Time and Date
When the recorder’s POWER/HOLD switch is
turned ON the [Time & Date] will be displayed
for two seconds. If the time and date is not
correct, set it using the procedure below.
1 Press the
+
or
–
button in the [Device
Menu] screen, then select [Time & Date].
See P.34 regarding the menu.
2 Press the PLAY/OK or 9 button.
The time and date screen appears. The hour
indicator flashes, indicating the start of the time
and date setup process.The following steps are
the same as Step 1 through Step 3 of “Setting
Time and Date (Time & Date)” (
☞ P.17).
3 Press the F3(EXIT) or 0 button to
complete the setting.
Setting T
ime and Date
3 M 15 D 2009 Y
15 D 3 M 2009 Y
2009 Y 3 M 15 D
BACK EXIT
Device Menu
Beep
Cue/Rev Sound
Time & Date
USB Class
Reset Settings
Power Save
Setting Time and Date (Time & Date)
Notes
• If you press the STOP button during the setup operation,
the settings are cancelled, and the recorder returns to the
previous screen.
• You can set the time and date from your PC using DSS
Player software ( ☞ P.59).