Brother DCP-353C - Manual (Page 20)

Installing the Driver & Software
18
STEP 2
Windows
®
W
ind
ow
s
®
Netw
o
rk
2
For Network Interface Users (DCP-560CN only)
(For Windows
®
2000 Professional/XP/
XP Professional x64 Edition/Windows Vista™)
Important
Make sure that you have finished the
instructions from STEP 1 Setting Up the
Machine on pages 4 through 11.
Note
• The supplied CD-ROM includes ScanSoft™
PaperPort™ 11SE. This software supports
Windows
®
2000 (SP4 or greater), XP (SP2 or
greater), XP Professional x64 Edition and
Windows Vista™ only. Please update to the latest
Windows
®
Service Pack before installing MFL-Pro
Suite.
• Please close any applications running before
installing MFL-Pro Suite.
• Make sure there are no memory cards or a USB
Flash memory drive inserted into the media drives
or USB direct interface at the front of the machine.
1
Disconnect the machine from the power socket.
2
Using both hands, use the plastic tabs on both
sides of the machine to lift the scanner cover
until it locks securely into the open position.
3
Connect the network cable to the LAN socket
marked with a
symbol. You will find the
LAN socket inside the machine on the left as
shown below.
4
Carefully guide the network cable into the
trench as shown below, following the trench
around and toward the back of the machine.
Then, connect the cable to your network.
Improper Setup
Make sure that the cable does not restrict the
cover from closing, or an error may occur.
Note
If both USB and LAN cables are being used, guide
both cables through the trench with one on top of
the other.
5
Lift the scanner cover to release the lock .
Gently push the scanner cover support
down
and close the scanner cover .
6
Turn on the machine by connecting the power
cord.