ATTO Technology 2700C - Manual (Page 39)

vi
DisplayTraceLog
Displays the most recent page of trace log entries. The
optional parameter n is the number of lines to be
displayed as
a single page with no user
interaction. After the command has executed,
use +, - or = to scroll through the log. Type quit and
press Enter to exit the command.
DisplayTraceLog
DisplayTraceLogFilter
Filters the display of data for specific ports while in
DisplayTraceLog mode.
Default: all all all
set DisplayTraceLogFilter [FC | all] [fp | all] [none |
chkcond | all]
get DisplayTraceLogFilter [FC | all] [fp | all]
DPMTU
Controls the MTU, or maximum transmission unit, used
by the data port.
Default: 1514
set DPMTU [DPn | all] [1514 | 9014]
get DPMTU [DPn | all]
DumpConfiguration
Displays the iPBridge configuration to the ExpressNlAV
Advanced page text box, an available RS-232 or telnet
session.Results may be truncated in the ExpressNAV
readout.
DumpConfiguration
DumpEventLog
Dumps the entire contents of the event log to the
ExpressNlAV Advanced page text box, an available RS-
232 or Telnet session.Results may be truncated in the
ExpressNAV readout.
DumpEventLog
DumpTraceLog
Dumps the entire contents of the
Username to the
ExpressNlAV Advanced page text box, an available RS-
232 or telnet session.
DumpTraceLog
EmailFromAddress
Configures the Email address that the unit uses to
communicate with the Email server. Full Email address is
a fully qualified Internet Email address, not more than
128 characters long.
set EmailFromAddress [full email address]
get EmailFromAddress
EmailNotify
Regulates Email notification. If
VLAN is enabled, the
VLAN ID must be provided.
Default: disabled.
set EmailNotify [enabled | disabled] <[DPn] [VLAN ID]>
get EmailNotify
EmailNotifyAddress
Configures notification addresses. Index is a number
between 1 and 5. Full Email address is a fully qualified
Internet Email address, not more than 128 characters
long. Warning levels
None: no Emails are sent
Critical: only critical severity events engender an
Email
Warning: warnings and critical events precipitate
Email
All: all warnings, critical events and informational
messages warrant an Email.
set EmailNotifyAddress [index] [full email address]
[warning level]
get EmailNotifyAddress
EmailPassword
Configures the password which authenticates the login to
the SMTP Email server. The password must not be more
than 64 characters. A password is not required if the
Email server does not require authentication.
set EmailPassword
SaveConfiguration command required
EmailServerAddress
Configures the address of the server the unit must contact
in order to send out Email notifications.
Default: 0.0.0.0
set EmailServerAddress [IP address]
SaveConfiguration command required
get EmailServerAddress