Introduction, Commands, Sectio – Konica Minolta Magicolor 2350EN User Manual
Page 26
Introduction
22
Introduction
The PJL commands supported by your printer are identified and described in
this chapter. PJL commands are identified first and then followed by the
definition of environmental variables.
The commands and variables in the following sections are listed by name and
in alphabetical order.
Commands
Command
COMMENT
Syntax
@PJL COMMENT remarks [
Description Comments can be used to insert information within the
lines of a PJL job. This information has no effect on the
printer or on any other commands used in the PJL job.
Information in Comments are primarily used to contain
notes about the preceding or following commands used in
the job.
Notes Remarks can be any text using Roman-8 characters
(Codes 33-255).
Remarks must start with a printable character.
Command
DEFAULT
Syntax
@PJL DEFAULT [LPARM : personality] variable
= value [
Description This command can be used to change the User Default
settings of the printer. DEFAULT is used with environmental
variables to set the user default value of a printer parame-
ter. See the next section for a listing of variables that are
available for your printer.
Notes The User Default Settings are also configurable from the
printer’s control panel. Using the DEFAULT command does
not affect the Factory Default Settings of the printer.
Changes to the Default Settings are not activated until a
RESET command has been executed, the job ends, or a
on page 27 for more information.