Konica Minolta bizhub C650 - Manual (Page 12)

C650 1-7
Security 1
Security
Chapter 1
Network Connection Requirements for the Machine
Packets being transmitted over the LAN installed in the office, in which the machine is installed, should be
protected from unauthorized manipulation. If the LAN is to be connected to an outside network, no unautho-
rized attempt to establish connection from the external network should be permitted.
- If the LAN, in which the machine is installed, is connected to an outside network, install a firewall or
similar network device to block any access to the machine from the outside network and make the nec-
essary settings.
- Configure the LAN installed in the office, in which the machine is installed, by using a switching hub and
other devices to ensure that the packets are protected from unauthorized manipulation.
- Provide an appropriate network control at all times to make sure that no other copying machine is con-
nected without prior notice to the office LAN to which this machine is connected.
User information control server control requirements
The server administrator is required to apply patches and control accounts for the user information control
server connected to the LAN within the office, in which this machine is installed, to ensure operation control
that achieves appropriate access control.
Security function operation setting operating requirements
The Administrator should make sure of correct operation control so that the machine is used with the En-
hanced Security Mode set to [ON].
Operation and control of the machine
The Administrator of the machine should perform the following operation control.
- The Administrator of the machine should log off from the Administrator Settings whenever the operation
in the Administrator Settings is completed. The Administrator of the machine should also make sure
that each individual user logs off from the User Authentication mode after the operation in the User Au-
thentication mode is completed, including operation of the Secure Print Document file, User Box, and
User Box file.
- The Administrator of the machine should set the HDD Lock Password according to the environment, in
which this machine is used. If the machine is mounted with the optional Security Kit SC-503, the
Administrator should also set either the HDD Lock Password or Encryption Key, or both.
Machine Maintenance Control
The Administrator of the machine should perform the following maintenance control activities.
- Provide adequate control over the machine to ensure that only the Service Engineer is able to perform
physical service operations on the machine.
- Provide adequate control over the machine to ensure that any physical service operations performed
on the machine by the Service Engineer are overseen by the Administrator of the machine.