Konica Minolta bizhub 360 - Manual (Page 185)

4 Application Software
4-30 360
Application Software
Chapter 4
message appears that tells that authentication has not been suc-
cessful for any subsequent operation for authentication. The ma-
chine is then set into an access lock state, rejecting any more logon
attempts. To cancel the access lock state, the Administrator of the
machine must perform the Release Setting. Contact the Adminis-
trator of the machine.
? What happens if the Save these settings check box has been se-
lected?
% If the “Save these settings” check box has been selected, the User
Password entered is stored in the PC being used. If you do not want
the User Password stored, clear the “Save these settings” check
box.
6
Enter the desired User Box No. and 8-digit User Box Password.
7
Click the [OK].
? What happens if there is a mismatch between the User Box No. and
User Box Password?
% If there is a mismatch between the User Box No. and User Box
Password, a message appears that tells that authentication has not
been successful. Click [OK] and perform step 6 once again.
% If the Enhanced Security mode is set to [ON], the entry of a wrong
User Password is counted as unauthorized access. If a wrong User
Password is entered a predetermined number of times (once to
three times) set by the Administrator of the machine or more, a
message appears that tells that authentication has not been suc-
cessful for any subsequent operation for authentication. The ma-
chine is then set into an access lock state, rejecting any more logon
attempts. To cancel the access lock state, the Administrator of the
machine must perform the Release Setting. Contact the Adminis-
trator of the machine.
8
Select the desired document data and click [Read].
360_security_E.book 30 ページ ２００７年３月７日 水曜日 午後２時５０分