Squarefold module fault codes – Konica Minolta bizhub PRO 2500P User Manual
Page 86
86
Chapter 7 Troubleshooting
SquareFold module fault codes
SquareFold module fault codes
Feed Errors
If feed errors occur, the feed belts need to be cleaned or the pressure on the upper
feed belts needs to be increased. To clean the feed belts, (
). To increase the pressure on the upper feed belts follow this procedure.
[45]
[88]
[88] Spring in normal position
Step
Action
1
Open the top cover.
2
Place both springs in the upper position.
3
Close the top cover.
This manual is related to the following products: