Konica Minolta bizhub PRO 2500P - Manual (Page 23)

23
Remove/replace staple cartridge
How to replace the staples after a staple jam or empty staple cartridge
indication.
[14]
5 Insert the cartridge into
the stapler head with
the staples facing
towards the head
mechanism. The
cartridge should be
placed flat on the slide
on the bottom of the
stapler head and
pushed firmly into the
stapler head. [20]
6 Hold the staple
cartridge firmly in
place and push down
the cartridge locking
lever. [21]
Note: It is important that the cartridge is held firmly in position once
it is inserted into the stapler head.
If the cartridge is allowed to move away from the stapler head before
the locking lever is in engaged, remove cartridge and tear off 20 mm
(approx. 1 inch) of staples along the staple tear line.
Step Action Description
Step Action
1 Follow step 1-6 on the previous page.
2 Close the top cover.
3 Feed in a four-page set. Staple recovery will now begin.
4 The Booklet maker has now recovered and production can continue. If the
problem persists and no staples have been fed, the display will indicate
that again. In such a case: repeat this procedure. If the problem still
persists, perform the Removing/replacing Stapler Head procedure.