Konica Minolta bizhub PRESS C1070 - Manual (Page 13)

bizhub PRESS C1070/C1070P/C1060 2-4
2.2 Installation Procedures 2
5
Pull out the fixing plate [1] forward.
6
Holding the handles on the rear and front sides [2] of the fus-
ing unit [1] by both hands, slide the fusing unit [1] forward to
the position of arrow mark.
Please be careful when working on the fusing unit; the unit is
extremely hot.
7
Holding the handles on the rear and front sides [2] of the fus-
ing unit [1] by both hands, remove the fusing unit [1].
Place the removed fusing unit on the flat surface.
8
Holding the handles on the front and rear sides [2] of EF-103
[1] with both hands, set EF-103 [1] on the fixing position with
arrow mark.
NOTICE
Make sure that the exit section is open before setting EF-103
to the machine. When you try to set the fusing unit with the
exit guide unit closed, the machine may be damaged.
9
Holding the handles on the front and rear sides [2] of EF-103
[1] with both hands, slide it to the direction of arrow until it
knocks in place.
Return the fixing plate [3] to its original position.