Konica Minolta bizhub 750 - Manual (Page 85)

3 Using scan functions
3-6 bizhub 750/600
Usin
g sca
n
fu
nct
ions
Chapter 3
To use a program
“Program” refers to the set of destinations and scan
settings that are registered together. These are
convenient for frequently sending transmissions with
the same settings.
If a destination has not been registered with a program,
the destination cannot be specified.
The following procedure describes how to send data
by selecting a program that has been registered in
advance.
% In the Program screen, touch the button for the
desired program.
– Touch [Index List] to select the page of program
destinations to be displayed.
– To cancel the setting, touch the button again to
deselect it.
– To clear all of the selected destinations, press the
[Reset] key.
– To check/delete the specified destination, press
the [Mode Check] key. For details on checking/
deleting destinations, refer to “Checking the
settings (Mode Check)” on page 5-10.