5 connecting a copier to the netware server, Supported environments, Setting up netware 4.x/ 5.x/ 6 print server mode – Konica Minolta KN-419 User Manual
Page 38
Connecting the Computer and Copier
7
KN-419
7-9
7.2.5
Connecting a Copier to the NetWare Server
Supported Environments
The controller supports the system environments described below.
Setting Up NetWare 4.x/ 5.x/ 6 Print Server Mode
1
Log in with administrator privileges.
2
Start up NWadmin.
3
Select the print service system or category container, and then select
“Print service quick setup” from the Tool menu.
4
Enter settings into the
Print server name
,
Printer name
,
Print queue
name
, and
Volume name
boxes, select
Other/Unknown
under
Type
name
, and then save the settings.
✎
Note
Specify the users who can use the queue, printer options, number
of queues, and password. Refer to the NetWare documentation for
details.
5
Start up PageScope Light/Network Management Utility Light and log
in to the Administrator mode, select
NetWare Configuration
from the
“Network” tab, and then use PageScope Light/Network Management
Utility Light to specify the following settings on the copier. (Refer to
“8 Using PageScope Light/Network Management Utility Light” for
details.)
6
Load MONITOR.NLM using the NetWare server console.
NetWare version
Protocol
Emulation
Service mode
NetWare 4.x
IPX
NDS / Bindery
PServer / NPrinter
NetWare 5.x/6
IPX
NDS / Bindery
PServer / NPrinter
TCP/IP
NDPS (lpr)