Konica Minolta bizhub PRESS 2250P - Manual (Page 5)

Operator Manual STR0202 & SFM0704
DBCB-0512-0066-V005
STR0202 2-Side Trimmer & SFM0704 Square Fold Module
V005 RI01 23-04-2012 DBCB-0512-0066-V005 - 5 -
2. General
With the addition of the 2-Side Trimmer STR0202 to the SDD product range, a cost effective full-bleed
solution is available which has a small footprint and is easily to operate. This machine is designed with high
reliability in mind, which means that it has been designed for long run production .
The main goal of the 2-Side Trimmer, further referred to as STR, is that it can be used for trimming the bleed
off the booklet. Booklets with a maximum up to 25 sheets 80g/m2 (50 folded)
can be trimmed from 2mm to
35mm on each short edge of the booklet, to a minimum of 200mm and a maximum of 320mm finished size.
Thereby it is also possible to trim asymmetrical. All actions concerning operating the STR and adjusting the
trim settings can easily be done by using the User Interface (UI) on the STR.
For example in the schedule mentioned below is schematically rendered some results which are possible
with the STR by using a different Center Offset (symmetrical or asymmetrical):
Centre Offset:
15mm
Centre Offset:
-15mm
Centre Offset:
0mm
33,5mm Waste
33,5mm Waste
3,5mm Waste 18,5mm Waste
3,5mm Waste
Finished Size:
260.0mm
Infeed Size:
297.0mm
18,5mm Waste