Sangean DDR-43+ - Manual (Page 47)

45
GB
System reset
If your radio fails to operate correctly, or some digits on the display are
missing or incomplete carry out the following procedure.
1. Press and hold the Menu button so that the display shows
“Set Brightness” on the lower line of the text display.
2. Press and release the Tuning Up or Down buttons until the display
shows “System reset”.
3. Press and release the Select button. The display will show
“Press SELECT to reset”.
4. Press and release the Select button again to confirm the
reset operation.
5. After a system reset, all radio station presets will be set to empty.
Alarms will be cancelled, audio equaliser, display brightness and
touch panel settings will have been set to their default values.
The clock will be reset and the unit will behave as when first switched
on (see page 9).
In case of malfunction due to electrostatic discharge, reset the product
using the above procedure. In some circumstances it may be necessary
to disconnect and then reconnect the mains power in order to resume
normal operation.