Sangean DDR-43+ - Manual (Page 12)

10
Operating your sound system - DAB+
1. Fully extend the telescopic aerial. If your sound system is in
standby mode, press the On / Standby button to switch it on.
2. Press and release the Radio button to select DAB+ mode.
The display will show “DAB” for a few seconds.
3. If this is the first time the sound system is used a quick scan of the
DAB+ channels may be carried out (depending on whether scanning
was already completed in standby mode). If the radio has been
used before, the last used station will be selected.
4. When first switched on, the first station in the list of stations will
be shown. Press and release the Select button to tune to this station
or press the Tuning Up or Down buttons to select an alternative
station. See selecting a station on the following page. The display
will show the station name on the upper line of the text display and
broadcast information on the lower line.
5. If the station list is still empty after the scan operation or if the
selected station cannot be received your radio will display
“Service not available”.
6. If no signals are found it may be necessary to relocate your sound
system to a position giving better reception, and then repeat the scan
using the Auto-tune facility (see Finding New Stations on page 13).
Note that radio station name and frequency displays shown in
this user guide may differ from those that you see on your radio.
Broadcasters may change radio station names that are transmitted,
and the frequencies used for DAB+ and FM radio stations may not be
the same in all parts of the country.