Sangean DDR-43+ - Manual (Page 24)

22
Presetting stations
You may store your preferred DAB+ and FM radio stations to the preset
station memories (1 to 10). The procedure for setting presets and using
them to tune stations is the same for FM and DAB+ modes, and is
described below. Note that the radio stores FM and DAB+ presets
separately and so there are ten of each. Presets are preserved in the
event of a power failure.
1. Press the On / Standby button to switch on your sound system.
2. Tune to the required station as previously described.
3. Press and hold down the required Preset button (1 to 10) until the
display shows for example “Preset 1 saved”. The station will be
stored using the chosen preset number. Repeat this procedure for
the remaining presets as you wish.
4. Preset memories which have already been stored may be overwritten
by following the above procedure if required.
Recalling a preset station
1. Press the On / Standby button to switch on your sound system.
2. Select the required waveband by pressing the Radio button.
3. Momentarily press the required Preset button (1-10) to cause your
radio to tune to the station stored in preset memory.
Note:
If you have not previously stored a preset station and the preset
button is pressed “Empty preset” will be displayed.