Lenovo ThinkServer TD200 - Manual (Page 93)

ok
system> passwordcfg
Security Level: Customize
-exp: 365
-cnt: 5
-nul: allowed
portcfg command
Syntax
portcfg [options]
portcfg [options]
options:
-b baud_rate
-climode cli_mode
-cliauth cli_auth
Description
Use the portcfg command to configure the serial port. To change the serial port
configuration, type the options, followed by the values. To change the serial port
configuration, you must have at least Adapter Networking and Security
Configuration authority.
The parameters are set in the hardware and cannot be changed:
v 8 data bits
v no parity
v 1 stop bit
The following table shows the arguments for the options.
Option Description Values
-b Baud rate 9600, 19200, 38400, 57600, 115200, 230400
-climode CLI mode none, cliems, cliuser
v none: The command-line interface is disabled.
v cliems: The command-line interface is enabled
with EMS-compatible keystroke sequences.
v cliuser: The command-line interface is enabled
with user-defined keystroke sequences.
Example
system> portcfg
-b
: 115200
-climode : 2 (CLI with user defined keystroke sequences) system>
system>
srcfg command
Syntax
srcfg [options]
options:
-exitcliseq exitcli_keyseq
Description
Use the srcfg command to configure the serial redirection. Type srcfg to display
the current configuration. To change the serial redirect configuration, type the
Chapter 7. Command-line interface 87