Kodak DP800 - Manual (Page 46)

Contents
46
Changing batteries in the remote control
Figure 13 shows the remote control with the battery lid
removed. Slide off the battery lid, remove the batteries,
and replace them with fresh batteries of the same type.
Be sure to insert the new batteries with the + and -
poles correct. Slide the battery lid back on again.
Changing/installing the lamp
Figure 14 illustrates how to remove the lamp module
from the Projector.
The lamp producer specifies an average lifetime. You
should not use the lamp beyond this average lifetime.
offers no warranty on the lamp.
1. Switch off the Projector and unplug it from the wall
outlet. The lamp assembly lid is locked as long as
the Projector is switched on.
NOTE
Take care when removing the lamp, it may
be very warm! Do not under any circumstance
touch the lamp itself, the lamp holder or the lamp
reflector. Use only the handle to remove the lamp
module.
7 Maintenance
Fig. 13, Batteries and covers on the remote control.
WARNING! Never work inside the Projector
if it is connected to the mains! Always
unplug it from the wall outlet when
changing the lamp!