Vollrath F431 - Manual (Page 15)

9
SECTION 3
INITIAL SET-UP AND OPERATION
3.1 SAFETY PRECAUTIONS
SAFE OPERATION IS NO ACCIDENT; observe these
rules:
A. Know the machine. Read and understand the
operating instructions.
B. Notice all warning labels on the machine.
C. Wear proper clothing. Avoid loose fi tting garments,
and remove watches, rings or jewelry which could
cause a serious accident.
D. Maintain a clean work area. Avoid accidents by
cleaning the area and keeping it clean.
E. Stay alert at all times. Know which switch, push
button or control you are about to use and what
effect it is going to have.
F. Disconnect electrical power for maintenance.
Never attempt to repair or perform maintenance
on the machine until the main electrical power
has been disconnected.
G. Do not operate under unsafe operating conditions.
Never operate this machine if unusual or
excessive noise or vibration occurs.
3.2 OPERATING CONTROLS AND INDICATORS
Before operating the machine, it is required that the op-
erator know the function of each operating control. Refer
to Figure 3-1 for the location of the operating controls on
the machine. For the information regarding error codes
displayed on the control panel, refer to the troubleshooting
section of this manual.
WARNING
Hazardous voltage
The Main Freezer Power switch must be placed in
the OFF position when disassembling for cleaning or
servicing. The machine must be disconnected from
electrical supply before removing any access panel.
Failure to disconnect power before servicing could
result in death or serious injury.
Figure 3-1 Controls
Left Freezing Cylinder
OFF/ON Switch
Right Freezing Cylinder
OFF/ON Switch
PUSH TO
FREEZE
CLEAN
Main Freezer Power
OFF/ON Switch
Cab Off
Indicator Light