Vollrath F111 User Manual
Page 16
Owner’s Manual #513532-5 Rev.1
10
E111I/F111I Model Machines
3.8 ASSEMBLING MACHINE
To assemble the machine parts, refer to the following steps:
NOTE
Petrol Gel sanitary lubricant or equivalent must be
used when lubrication of parts is specifi ed.
NOTE
The United States Department of Agriculture and
the Food and Drug Administration require that lubri-
cants used on food processing equipment be certi-
fi ed for this use. Use lubricants only in accordance
with the manufacturer’s instructions.
A.
Assemble all o-rings onto parts dry, without
lubrication. Then apply a thin fi lm of sanitary
lubrication to exposed surfaces of the o-rings.
Apply a thin fi lm of sanitary lubricant to metal
part of rear seal. Also apply a thin fi lm of sanitary
lubricant inside and outside of the front auger
support bushing.
B.
Assemble the rear seal onto the auger with the
large end to the rear. Be sure the o-ring is in place
before installing the rear seal.
C.
Lubricate the auger drive (rear) with a small
amount of white socket lubricant. A small container
of socket lubricant is shipped with the machine.
D.
Screw the springs onto the studs in plastic
fl ights. Springs must be screwed into the fl ights
completely to provide proper compression (Fig.
3-7).
E.
Install the two plastic fl ights onto rear of the auger
and insert part way into machine barrel.
F.
Install the remaining plastic fl ights, push the auger
into the machine barrel and rotate slowly until the
auger engages the drive shaft.
G.
Install the bushing and auger support into the front
of the auger with one leg of the support pointing
straight down (“Y” position).
H.
Install the spigot body with o-ring into the front
door from bottom (Fig. 3-8). Push straight up until
the spigot is in place.
I.
Install the front door on the machine.
J.
Install the circular knobs on the machine studs.
K.
Look for the proper seal between the freezing
cylinder, o-ring, and front door.
CAUTION
Overtightening or uneven tensioning of circular
knobs may cause damage to front door and cause
leaking. Hand tighten circular knobs evenly.
Figure 3-8 Front Door Parts
Figure 3-7 Auger Springs