Silent Call SD4-SS - Manual (Page 20)

20
that you MUST remove the batteries first or the switch setting will
not take effect.
3. Locate the address switch on the transmitter circuit board that
has 5 small dip switches. Set the switches to any combination
that you want. For Example: 1, 2 ON 3, 4, 5 OFF. This gives your
transmitter an “address.” Note: Do NOT set the switches to the all
“ON” or all “OFF” position.
4. Reinstall the batteries and replace the access panel.
5. Refer to your specific Signature Series Receiver instruction
manual for programming your receiver to your newly changed
transmitter address.
Mounting
First, determine the best location for the smoke detector, one that
provides a strong wireless transmission path and proper smoke
detection. A good transmission path must be established from the
proposed mounting location before permanently installing the detector.
To check, perform the test described in the TESTING SIGNAL
STRENGTH section of this manual. To mount the detector, perform