Revolabs Solo Executive Operation Manual User Manual

Page 29

- 26 -

3. Release the button after the channel LED flashes GREEN twice for

synchronized Mode A. Release the button after the channel LED flashes
green three times for synchronized Mode B. If you miss the Mode you are
configuring, the system will continue to cycle through all options.

4. Repeat steps 1 to 3 with the CHANNEL 3 button

5. Repeat steps 1 to 3 with the CHANNEL 5 button (8 channel system only)

6. Repeat steps 1 to 3 with the CHANNEL 7 button (8 channel system only)

When the base station is powered-on again, the LEDs will give one GREEN
flash on channels 1, 3, 5, and 7 to indicate that the system is in single system
mode, twice to indicate A Mode, and three times for B Mode.

Note 1: Always confirm that the Base Station set to the “Local” switch setting is
in Mode A, and that the “Remote” Base Station is in Mode B.

Note 2: When using a 4-channel system with an 8-channel system, assign the 4-
channel system to ”Local” and Mode A.

Note 3: Always confirm that all transceivers are set at the same channel setting
on each Base Station.

Note: Revolabs Solo™ Single Channel system does not offer synchronized
operation.