Norgren L73C Series - Manual (Page 2)

L73M, L73C
Installation & Maintenance
Instructions
WARNING
These products are intended for use in industrial
compressed air systems only. Do not use these products
where pressures and temperatures can exceed those listed
under Technical Data.
Polycarbonate plastic reservoirs can be damaged and
possibly burst if exposed to such substances as certain
solvents, strong alkalies, compressor oils containing ester-
based additives or synthetic oils. Fumes of these
substances in contact with the polycarbonate reservoir,
externally or internally, can also result in damage. Clean
with warm water only
Use metal reservoir in applications where a plastic
reservoir might be exposed to substances that are
incompatible with polycarbonate.
In lubrication applications some oil mist may escape
from the point of use to the surrounding atmosphere.
Users are referred to safety and health standards for
limiting oil mist contamination and utilization of protecting
equipment
Before using these products with fluids other than air,
for nonindustrial applications, or for life-support systems
consult Norgren.
IM-180.400.02 (5/02)
Supersedes 9/98 a subsidiary of IMI plc
© Norgren 2002