Norgren 82630 Series - Manual (Page 2)

82530/82630
82˙3˙˙˙.8001.˙˙˙˙˙
N/en 5.8.102.02 07/14
2014-5732d
Our policy is one of continued research and development. We therefore reserve the right to amend,
without notice, the specifications given in this document. © 2014 Buschjost GmbH
Frequency Substitute
See table frequency codes xx
Voltage Substitute
See Voltage codes xxx
Further versions on request!
Standard solenoid systems
Design DIN VDE 0580
Voltage range ±10%
Duty cycle 100% ED
Protection class EN 60529 IP65
Socket Form A acc. to DIN EN 175301-803 (included)
According to DIN VDE 0580 at a solenoid temperature of +20°C.
At operating state temperature the input power of a coil decreases by up to
ca. 30% due to physical reasons.
Electrical details for all solenoid systems
Voltage and Frequency Solenoid 8001
Code
Voltage
Code
Frequency
Voltage Frequency Power consumption
Inrush
Holding
024 00 24 V d.c. - 12 W 12 W
024 50 24 V a.c. 50 Hz 20 VA 20 VA
110 50 110 V a.c. 50 Hz 20 VA 20 VA
120 60 120 V a.c. 60 Hz 20 VA 20 VA
230 50 230 V a.c. 50 Hz 20 VA 20 VA
ATEX category Protection class Solenoid Standard voltages
II2GD EEx me II T3 T 140°C 8041 24 V d.c., 110 V a.c., 230 V a.c.
Attention!
The conditions imposed on the Ex approvals lead to reduction of the permissible
standard temperature ranges in the cases of explosion protected solenoids.
Additional solenoid systems
Option selector
Thread form Substitute
ISO G 5
NPT 6
Port size Substitute
1/4 0
3/8 1
1/2 2
Valve options Substitute
Seat seal FPM,
for fuel and oil,
max. fluid temperature +110°C
03
Seat seal EPDM,
for hot water,
max. fluid temperature +110°C
14
Degreased version,
Seat seal FPM
18
Operating pressure 0 ... 20 bar,
only for NBR and a.c. solenoid
22
Seat seal HNBR,
for hot water and steam,
Operating pressure 0 ... 6 bar,
Fluid temperature 0 ... +150°C
51
Option Solenoid Standard voltages
D.c. solenoid with rectifier for a.c. only 8004 24 V d.c., 110 V a.c., 230 V a.c.
Additional solenoid systems
x