MyWeigh Flipscale F2 - Manual (Page 6)

key to turn the scale off
* Z/T
Press Zero to reset the scale to zero. This can be used for eliminating from a
sample (or a Tray/Container) the weight value of a container. Th weight is
permanently removed for the remainder of the procedure. Just turn the scale
ON, place the tray or container on weighing platform, and press the ZERO key.
The scale will show 0.0 (or 0.00) on the display and you can add items to the
container/tray.
NOTE: When all weight are removed from the weighing tray, the tared value of
a container will be displayed as a negative number. Cycle the power on the
scale to reset the scale to zero.
** These electronic scale are precision instruments. Avoid disturbing
environmental conditions such as currents, vibrations, strong electrical and
magnetic fields as well as a rapid change of the ambient temperature.
* LIGHT (Backlight / CAL)
To turn on the backlight, simply turn the scale on then press the “light” key (near the display) The
backlight will remain on for approximately 5 seconds.
** These electronic scale are precision instruments. Do not attempt to weigh near an in-use cell phone,
radio, computer or other electronic device. These devices emit RF and can cause incorrect or unstable
scale readings. Only operate in an interference free, very stable environment. If your scale ever
performs poorly, try moving the scale to a different location.
Please take good care of your Flipscale F2 !
My Weigh is the Best Weigh