MyWeigh Pointscale 5.0 - Manual (Page 5)

5. Press the CAL key. The display will show CAL and then PASS, calibration is complete. Gently
remove the weight and turn the scale Off.
POINTSCALE 150 VERSION 1.0, 2.0, AND 3.0 CALIBRATION
Please turn the scale ON and allow it to warm up for 30 seconds before calibration. If Possible please
calibrate the scale on your SCALEPAD (included in the box), a mousepad or similar surface (These pads
are very stable and absorb vibrations). Repeat calibration at regular intervals if the scale is subject to
weather or altitude changes. Incorrect calibration can occur if you do not follow the steps exactly. If
your scale does not perform accurately, please try replacing your batteries before you calibrate.
 Place the scale on a Flat stable surface. Turn the scale on and allow it to stabilize for 30 seconds.
 Press and hold the "CAL/MODE" key for 5 seconds, CLO will briefly display on the screen and
then 100.0 will appear. you must wait for 100.0 to appear before proceeding.
 Gently place the 100 gram weight on the scale, wait 3 seconds, then press the "OFF" key. Only
press it once.
 Wait 10 seconds, the scale should show CLF and then return to active weighing. Gently remove
the weight. Sometimes the scale may show a leftover value such as 0.1g, If you wish you may re-
zero the unit by pressing the tare key.
Note: If after calibration your scale does not read accurately, this indicates calibration error and the
calibration process should be repeated. Please calibrate on a scalepad, mousepad or similar surface if
possible.
Inaccuracy / Error
The primary reasons for inaccuracy or malfunction are low batteries, incorrect calibration, overload or
operating on an unstable surface. Please keep this in mind and maintain and operate your scale
properly. The scale is a precise instrument and must be handled with the utmost care and caution.
POWER UP SEGMENT TEST
When first turning the unit on, all segments of the display will appear as shown below. This display will
remain for approximately 3 seconds and then reset to zero. The display may also change brightness
during this time and show a blank screen for a moment before 0.0 appears + 8.8.8.8
STABLE READING INDICATION
This is a very precise scale - the display may seem to wander or jump when weighing. This is due to air
currents or vibrations. Stable weighing is achieved when the display remains fixed for 3 seconds.
OVERLOAD
When an applied load exceeds the capacity. "EEEE" or "HHHH" will appear on the display. Remove